iGeelee Hydraulic Busbar Punching Tool,Hydraulic Puncher,Hydraulic Hole Digger,WK-8

Product display

Features:

1. Before punching, punched a hole (Ø11.5mm) by electric drill.

2. Screw the rod of piston into the thread hole of cylinder. Then mount the metal gasket to the rod. Make the metal plate suitable mounted with the rod and then set the down punch. Make sure the metal plate is well connected with the upper punch..

3. As the step 2, please make sure the knife edge next to metal plate.

4. Turn off the turn screw, pump the movable handle repeatedly, the piston working, oil pressure rising, the punching power between upper punch and down upper increased. Keep punch working on the metal plate until punch through.

5. Loose the turn screw, uninstalled the full oil pressure. Finish working after above 4 steps.

6. Screw off the upper punch and clean the scraps from down punch for using next time.

Data Sheet